(v1.00.02) U-Boot 2.1.4 (Jan 28 2008 - 14:56:42) DRAM: 64 MB Flash: 8 MB In: serial Out: serial Err: serial Net: adm8668_net Hit any key to stop autoboot: 0 ## Booting image at b0040000 ... Check vendor string... Image Name: ADM8668 Linux Kernel(2.4.31) Created: 2011-01-18 9:18:36 UTC Image Type: MIPS Linux Kernel Image (uncompressed) Data Size: 2490304 Bytes = 2.4 MB Load Address: 80400000 Entry Point: 80400000 Verifying Checksum ... OK OK Starting kernel ... LZMA kernel loader lzma data @ 0x804001e0 - 0x804daf45 load addr @ 0x80002000 jump table @ 0x83ff5340 Decompressing kernel...success! bootconsole [early0] enabled Board info: Board ID: 0x80000008 RAM size: 64 MB NOR start: 0xb0000000 NOR size: 0x800000 CPU revision is: 0001800b (MIPS 4Kc) Determined physical RAM map: memory: 04000000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00004000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00004000 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256 Kernel command line: rootfstype=squashfs root=/dev/mtdblock1 console=ttyS0 PID hash table entries: 256 (order: -2, 1024 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Primary instruction cache 8kB, VIPT, 2-way, linesize 16 bytes. Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes Memory: 62080k/65536k available (2294k kernel code, 3456k reserved, 333k data, 148k init, 0k highmem) NR_IRQS:32 ADM8668 CPU clock: 200 MHz Calibrating delay loop... 199.47 BogoMIPS (lpj=997376) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 NET: Registered protocol family 16 adm8668_pci_init() bio: create slab at 0 pci 0000:00:01.0: BAR 0: assigned [mem 0x16000000-0x16007fff] pci 0000:00:01.0: BAR 0: set to [mem 0x16000000-0x16007fff] (PCI address [0x16000000-0x16007fff] Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 adm8668_uart.0: ttyS0 at MMIO 0x1e400000 (irq = 6) is a adm8668_uart console [ttyS0] enabled, bootconsole disabled console [ttyS0] enabled, bootconsole disabled ADM8668net driver version 1.1.15-NAPI (Feb 27, 2007) net eth0: ADM8668net at MMIO 0x11a00000 00:00:22:33:44:54, IRQ 7 net eth1: ADM8668net at MMIO 0x11600000 00:11:22:33:44:55, IRQ 8 squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 121 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled adm8668-nor: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0022cb Amd/Fujitsu Extended Query Table at 0x0040 Amd/Fujitsu Extended Query version 1.1. number of CFI chips: 1 adm8668-nor: Filesystem type: squashfs, size=1324kB Updating U-boot image: old: [size: 2490304 crc32: 0x3b206efb] new: [size: 917440 crc32: 0xf2131510] Done Creating 3 MTD partitions on "adm8668-nor": 0x000000040000-0x000000800000 : "linux" 0x000000120000-0x000000800000 : "rootfs" mtd: partition "rootfs" set to be root filesystem mtd: partition "rootfs_data" created automatically, ofs=270000, len=590000 0x000000270000-0x000000800000 : "rootfs_data" 0x000000020000-0x000000040000 : "uboot_env" TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Mounted root (squashfs filesystem) readonly on device 31:1. Freeing unused kernel memory: 148k freed - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - jffs2 not ready yet; using ramdisk mini_fo: using base directory: / mini_fo: using storage directory: /tmp/root - init - Please press Enter to activate this console. device eth0 entered promiscuous mode br-lan: port 1(eth0) entering forwarding state br-lan: port 1(eth0) entering forwarding state Compat-wireless backport release: compat-wireless-2011-01-06 Backport based on wireless-testing.git master-2011-01-05 cfg80211: Calling CRDA to update world regulatory domain cfg80211: World regulatory domain updated: cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) PCI: Enabling device 0000:00:01.0 (0000 -> 0002) PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 nf_conntrack version 0.5.0 (972 buckets, 3888 max) jffs2_scan_eraseblock(): End of filesystem marker found at 0x0 jffs2_build_filesystem(): unlocking the mtd device... done. jffs2_build_filesystem(): erasing all blocks after the end marker... done. mini_fo: using base directory: / mini_fo: using storage directory: /overlay BusyBox v1.17.3 (2011-01-13 20:51:58 EST) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M KAMIKAZE (bleeding edge, r24978) ------------------ * 10 oz Vodka Shake well with ice and strain * 10 oz Triple sec mixture into 10 shot glasses. * 10 oz lime juice Salute! --------------------------------------------------- root@OpenWrt:/#